2 Replies Latest reply on Feb 22, 2011 7:35 AM by misael.perez.martinez

    Loosing net name when copying or cutting nets.

    misael.perez.martinez

      Hello, I'm using DxDesigner 7.9.

       

      Whenever I copy or cut nets and paste them in another part of the schematic the net name gets replaced for a generic one (i.e. "_16N262").

       

      This is anoying since I often copy and paste small design sections between pages and just slightly modify the net name afterwards.

       

      Is there some setting or method to tell DxDesigner to preserve the net name when copying nets?

       

      Thanks,

      -- Misael