3 Replies Latest reply on Oct 20, 2011 8:39 AM by Joel_Pointon

    Multi-cores not showing terminals

    gary.fennell

      Hi,

       

      I have an odd problem when using Vesys harness (Classic)

       

      I have created a harness drawing which contains multicore cable and normal cables.

       

      My problem is that the terminals do not show in the wire table for the multi-core cables.

      The normal cables are fine.

       

      So, in the same wire table, all my normal cables have terminals shown, but none of the multi-core cables have terminals.

       

      Has anybody seen this before? Any ideas?

       

      Thanks

       

      Gary