9 Replies Latest reply on Jan 5, 2012 7:39 PM by yu.yanfeng

    Is it possible to end a trace with a straight cut and not a half-disk?

    A.Ozenne

      Hello,

       

      Do you know if it is possible to change the way a trace ends when connected to a pad?

       

      For instance in the image below, the trace width is such that when connected to the pad, the half-circle finish makes it go under the part. I would like to have a straight finish so that no matter what the width is, the trace does not exceed the component pad.

      Do you know how I could achieve this?

       

      trace.jpg

      Thank you.

       

      Anthony