9 Replies Latest reply on Apr 2, 2014 4:43 AM by chuckt

    Orcad to Pads

    rmoore

      Hello All,

           The company I work for uses Orcad for schematic capture and Pads for layout.  We recently had an issue where the trace widths were not implemented correctly on the layout.  We would like to be able to have the guy that generates the schematic specify the trace width.  I found the power net netlister written by Chuck Tidwell and understand that it is able to do this but I cannot figure out how.  I have tried adding properties to the net of interest in the schematic but it does not appear to change the netlist in the way I would think it should.  Could anyone give me some help with this?  Thanks in advance.

       

      Roger