1 Reply Latest reply on Aug 7, 2012 12:12 AM by paul_matthews

    How does .getFuseBlowTime() work?

    brian.schubert

      I noticed that their is a method called getFuseBlowTime().  However, after playing around with it for awhile I only seem to get a blow time of 0.0

       

      getFuseBlowTime.JPG

       

      How does this method work and why does the method seem to only return 0.0 for me?

       

      I am using %= instead of :=

        • 1. Re: How does .getFuseBlowTime() work?
          paul_matthews

          The fuse blowing time is calculated based on the type of fuse you are using. By default, the fuse type is ATO. (Quickstart/ComponentModels/CircuitProtectors/Fuse)

           

          The fuse blowing or not is based on the follwing calculation:

           

                            percentBlow %= blowCurrent * 100.0 / fuseRating;

           

          If a fuse does not blow, then the blow time is zero.

           

          Please note the fuse model with VeSys 2.0 / Capital v2011.1 were changed, if you have an earlier version of VeSys 2.0 / Capital then the blow time was not reported.

           

          The new models are located in /quickstart, however more than likely your existing design is still referencing the fuse model in /CHS.  You can change that by accessing the model attacher (RMB --> Analysis --> Attach) and picking the newer model. (/Quickstart/ComponentModels/CircuitProtectors/Fuse)

          I hope this helps

          Paul