0 Replies Latest reply on Jul 31, 2012 11:45 AM by yelu

    calibre view generation within cadence: schematic instance xxx not found

    yelu

      Hi,

       

      I was running Calibre Pex to generate a layout extracted (back-annotated) "calibre" view within Cadence 5 interface. In the process of calibre view generation, the CIW pops up a lot of warnings:

       

      Warning: Schematic instance xxx not found

       

      By looking at this thread: http://communities.mentor.com/thread/7906, seems I should consult some tech-note mg543224; but somehow I cannot access the technote.

       

      Could anyone tell me how to fix the above warning?

       

      Thanks a lot,

       

      Lu