deepak.v.katkoria

MG578740: HyperLynx PI: Exporting Power Nets From BoardSim to LineSim

Discussion created by deepak.v.katkoria on Aug 2, 2012
Latest reply on Aug 2, 2012 by weston_beal

there are still some improvement is needed for PI simulation.

 

For example I followed the MG578740 tutorial. however got stuck when simulating the selected power net in LineSim PDN editor.

 

1. PDN editor layout is bit different then original layout; specially capacitors are misplaced and thier vias.

2. When you open Decoupling wizard, a new net is generated automatically (which shorts the power and GND).

 

Any solution or different method is welcome..

Outcomes