Q2.  Why are the signal names not a part of this report? Only the ID tag is.

A2.  The signal names were typically used to describe the function of the wire and so not normally required by the Wire Harness Manufacturer whereas the Ident Tags are the labels that would typically be put onto the wires hence why these can be displayed on the reports.

If you are using VeSys Design it is possible to pass the Signal name over as an Ident tag when the wires are sent to a Harness.  To do this goto the Design Tools > Design Options > Wires and select "Use Signal Name as Ident Tag" (see below).

If you aren't using VeSys Design you could send me the DSI file, I have a tool that can move data between the different Wire Properties.

Q3.  What is the purpose of the wire option?

A3.  This is for composite harness drawing or in English a harness drawing that contains multiple harnesses for different variants, for example a vehicle may have 5 different harnesses for each trim level and rather than have seperate drawings you have 1 drawing which shows all possible options.

Hope this helps.