Using DESIGNrev to report all layers in GDS/OASIS file

Document created by chung_lee on Sep 14, 2012
Version 1Show Document
  • View in full screen mode

You can use the "layout peek" command in DESIGNrev to output design layers.

 

For instance, the example below shows the design contains layer 1 datatype 1 and  layer 2 datatype 0.

 

>calibredrv -a puts [layout peek a.gds -layers]
{1 1} {2 0}

 

The "layout peek" command is documented in the "Calibre DESIGNrev Referance Manual", Chapter "Batch Commands for Layout Manipulation".

Attachments

    Outcomes