Display just the pieces of a net, not the surrounding layers, using DESIGNrev

Version 1

    Select a piece of the net then do the following:
    (for how to specify net connectivity see "Extracting a Connected Net" in the DESIGNrev User's Manual)

    Before Calibre 2012.2
    1) Right click on a portion of the net and select Extract Net.
    2) Right click on that portion again and select Filter Net.

    After 2012.2
    1) Right click on a portion of the net and select Extract Net.

    A filter will be created for that net, it also contains the layers used on that net.

    The default initial selection is set to show the polygons on the layers on the net, and not show other polygons on those layers.

    For example, assume net1 has just layer M1.
    Filter Net will have:
         M1
         net1

     

    Both layers will be shown; note that they only contain data for net1.