pcb alignment problem

Document created by chu on Jan 4, 2018
Version 1Show Document
  • View in full screen mode

1.Teardrop then pads in the environment, but into
the Router gone, and then back to the pads found a short circuit, you can
ROUTER environment




 
 

2.For any angle version of the plate, sometimes lead to unable
to take the lead or can not hit via hole problem


3.When using the FOLLOW command along the edge of the board,
when pause again, the entire shape becomes a little weird, non-users need the
appearance, in addition, FOLLOW this command does not seem to pull the line,
pull the line when the case To the edge of the plate can not pull the case
smoothly


  4.differential Pairs Unable to move spring line
after completing accordions

Attachments

    Outcomes