3 Replies Latest reply on Aug 16, 2012 12:14 PM by jduquette

    Via in PCB Decal

    bruce.northrop

      Hi All- I have a 8 pin DFN package with the center GND slug that I need to build a decal for.  The data sheet specifies 3 vias to be used in the GND slug.  My engineer said that they would need to be blind vias.  Can I, or should I add them to the decal.  I would assume that the holes would be added as terminals adding complexity to the part.  It would seem to be easier to just add the vias during the layout process.  Any thoughts?

       

      Thanks,

       

      Bruce