1 Reply Latest reply on Feb 26, 2013 1:10 AM by Nuri

    Wire in Design too short

    htran1

      Hello, is there a way to length the wire in Design.  I adjust the wire to the desired length, then when I move the connector, the wire goes to a default length that is too short and the wire name covers it.

       

      Is there a way to lock or change the default wire length?

       

      Inserted is an example of what I am talking about.

       

      Capture.JPG

        • 1. Re: Wire in Design too short
          Nuri

          Hello,

          Unfortunately there isn't a way to control the minimum length of a wire, however you can turn off the auto-route facility (if you are using 2012.1 just click on the icon in the status bar, if you are using an earlier version then click on "Layout > Routing > Auto Routing").  With Auto Route turned off, moving the connector will not reset the wire lengths.

          Kind Regards,

          Nuri