2 Replies Latest reply on Apr 17, 2013 9:54 AM by daniel.wainwright

    (Answered) Part Lister and Property Definition confusion?

    daniel.wainwright

      Hello all,

      I have a situation where I can't seem to get all properties I have setup columns for to output values. I have added Supplier_Name and Supplier_PN using Property Definitions Editor. I have setup two more columns in Part Lister and selected from drop downs the newly defined property. When I run Part Lister the new columns are empty! Unless I delete the component from my schematic and then drag it back in from DxDatabook, then that instance will have values in all Part Lister columns.

       

      I can't really face doing that for hundreds of components... Is there some step I have missed somewhere that would get all components properties called up by Part Lister to be detected properly?

       

      Hope someone can help

       

      All the best,

      Daniel.

       

      Message was edited by: daniel.wainwright Tagged as answered in tittle since I couldn't find how to retrospectively make the thread a 'Question' thread to enable the built in answered tagging.