Hello,
After a conversion from DC to DXD we get pinnummers at the resistors,caps and elco's like this
This is the original from DC
Is there away to make them invisible in DXD
Regards
Mans
Hello,
After a conversion from DC to DXD we get pinnummers at the resistors,caps and elco's like this
This is the original from DC
Is there away to make them invisible in DXD
Regards
Mans
The DC2DX converter keeps the same visibility as set in DC (I've just checked this and confirmed with engineering). You might find you have 'Pin Numbers' turned on in 'Setup - Settings - Display'. This will display all Pin Numbers regardless of visbility setting, it is the equivalent of DC's Display Invisible Objects.
Rob
Message was edited by: robert_davies
The DC2DX converter keeps the same visibility as set in DC (I've just checked this and confirmed with engineering). You might find you have 'Pin Numbers' turned on in 'Setup - Settings - Display'. This will display all Pin Numbers regardless of visbility setting, it is the equivalent of DC's Display Invisible Objects.
Rob
Message was edited by: robert_davies