4 Replies Latest reply on Dec 9, 2013 6:37 AM by brian.schubert

    CANBUS T-Receptacle in harness


      We are using T-receptacles to connect multiple canbus cables together along with a terminating resistor. In our old harness software we were able to include the t-receptacle and terminating resistor in the harness drawing. In Design the tee is setup as device so it won't get pulled into harness. I attached a drawing of how we drew it with our old software. I would like it to be similar to this but maybe with the tee not actually shown connected but able to be placed close to the cable connectors. I just can't figure out how to get the t-receptacle to get brought into the harness