1 Reply Latest reply on Mar 11, 2014 8:32 AM by Nuri

    Two cavities, one node

    tara.jennens

      Connector 202 in the attached drawing has two cavities (3&4). They are both tied to one node. How do I separate them so I can bundle them to different ring terminals?

        • 1. Re: Two cavities, one node
          Nuri

          Hi Tara,

          It is not possible to split connector 202 into two nodes, instead if ring terminals fit into those cavities then the terminal P/N can be styled in the cavity chart. 

          Has your data been authored in Capital HarnessXC or did it come from earlier in the design process (e.g. Capital Logic)?

          Thanks,

          Nuri