Time of flight report is a report that generates time delay from one point to other i think since the address lines are mutipoint (mutiple destination ) the report generation is not providing the values ,create proper constrains for routing ie point to point matching rules in CES and check the report
I also faced issue like this. Try this one.
Copy your design to the new location.
While opening pcb file you shouldn't map it to the schematics. Then take the time of flight report.
I hope this one will help you.
Constraint setting is not a problem. I am getting perfect TOF report for another board, Without setting any constraints like source and destination.
I didn't get correct report even if the constraints are set in CES.
Your suggestion is also not working.
Can you provide how you need tof ball to ball or overall? if for some other board it is comming and for one board it is not comming means
unlock all the traces of the board and check because i found some time when you lock the trace in review trace length if the traces are locked the length will not be updated