I just recently upgrade to Pads 9.5, I went into setup/padstack and added all my vias. How do I get them to show up in the stack for all my PCB's?
Hi Danielle - thanks for your question. I am going to move this to the PADS specific product community where it will receive greater visibility. This Members Resources area is for general community resources, questions and suggestions.
Setup/Padstack/ turn via selection ON
I've done that, they show up in the original board that I made them in but they don't transfer to other boards. It's like they're only available for that specific board.
You can create specific board start-up file with via defined.
Retrieving data ...