Is there a way to fan out spare parts in xPCB?
I was convinced this works for the spare parts also, but apparently it does not.
However there is a workaround, You can add traces and via's to a spare component by using the Smart Utilities.
"Smart Utilities -> Routing -> Draw trace"
Fill in the required trace width and draw the traces and via's. It might be flagged as hangers during DRC.
I was convinced this works for the spare parts also, but apparently it does not.
However there is a workaround, You can add traces and via's to a spare component by using the Smart Utilities.
"Smart Utilities -> Routing -> Draw trace"
Fill in the required trace width and draw the traces and via's. It might be flagged as hangers during DRC.