I am using xPCB Layout Xpediton Enterprise X-ENTP VX.2
I have a PCB design already routed but have been requested to change my Via size from 8mil to 12mil.
I assume there is a setting that will allow me to change all of the placed vias at once.
Here are the steps I have already done/tried.
Changed the via in the Setup>Setup Parameters>Via Definitions to the new Via size (12mil).
and then ECO>Update Cells & Padstacks.
But my old via size is still on the board.
Any help would be appreciated as there are nearly 300 via's to be updated and I would rather not do this one at a time.
Thanks in advance,
Jacque
Hello Jacque,
Please try Edit-->Modify-->Pad stack processor . under pad stack tab left side exist pad stack and right hand side select your required via,
Refer below image,
Thanks,
Senthil