2007.5 now is released. It seems you can't do crossprobing between CES and Expedtition PCB(test on windows 2003 and use keyin flow).
What's that? The EE2007.5 release contains basic flaws that should have been found in the earliest stages of testing?
Welcome to the wonderful world of Mentor.
On a more serious note, I would leave it at least a couple of months before moving to EE2007.5 - Given the somewhat incredible 11 updates for EE2007.3, there is lots of potential for all sorts of things not to work in the short term.
So I have tested this and it does appear to be working.
In this image I point out that you need to pick the far left box next to the net name for it to work.
To add to Steve's excellent example above, I believe in previous releases the Cross Probe option was enabled automatically within CES, now is disabled by default and users must enable it before cross probing between CES and Expedition will functioned as desired. The pic below shows where to enable Cross Probing on the CES drop-down menu.
Seems to work OK in DC 2007.5 flow.
Was enabled from the start on my trial design.
After re-run configrator utility, the crossprobing is ok. I installed it on a vmware box and used it in TC mode,Possibley not get regs. Another problem in my side is that ouput-soldermask generator and pastepaste generator don't get invoked. Does any one check these two new features?
Retrieving data ...