1 Reply Latest reply on May 18, 2009 3:21 PM by Joel_Pointon

    How do I use centre tap for splice in Vesys Design

    nathanhong

      How to set centre strip wires in Vesys Design?

      hj.jpg

      Just like what we can set up in Vesys Harness

      Nathan.jpg

        • 1. Re: How do I use centre tap for splice in Vesys Design
          Joel_Pointon

          Hi,

           

          It is not possible to define a Centre Tap splice in VeSys Design because very few people use them.  We used to use Centre Taps but what we did was write a custom tool that converted the one single wire (from VeSys Harness) into 2 seperate wires that VeSys Design would accept on import - we crudely divided the length in 2.  This only worked for us because the Harnesses were the master drawings and the schematics were updated at a later date, if you are looking to use the Schematics to drive the Harnesses you might find this a little more challenging.