AnsweredAssumed Answered

Size of endpoint box

Question asked by rod_mcinnis on Dec 13, 2019
Latest reply on Dec 16, 2019 by charles.ietswaard1

I am using Xpedition 2.2, and I am struggling with unconnected, dangling nets. 

 

The end of a net that is not connected has a small box, I believe it is referred to as the 'endpoint box'. With my current settings this box is barely larger than the net width, and I must be zoomed in quite a lot before it is obvious. I have encountered a few instances where I had two nets overlapping instead of connecting.

 

I would like to make the endpoint box big enough so that it will be evident, even when zoomed out to a full page. 

 

I found the spot in settings where I was able to adjust the size of a connection dot, but I can't find where I can change the size of the endpoint box.  

 

Can it be changed?

Rod

Outcomes