AnsweredAssumed Answered

Setting Slave Registers in A2B Analyzer

Question asked by larsw on Jun 5, 2020
Latest reply on Jun 7, 2020 by larsw

Hi all,

 

I am trying to use A2B Analyzer in my A2B setup to replace an otherwise present active slave node. The active slave node sets its TDM configuration registers to specific values required for proper operation of the node:

I2SGCFG: 0xF0

I2SCFG:  0x1F
I can see these values are set in my A2B Analyzer App's BDD config, and they also show up in NetworkBuilder's TDM config tab.

 

However, when I want to perform a Node Simulation, select the corresponding slave node, connect and look at the dumped register values for the selected node, the value for both registers is always 0x0, causing the A2B analyzer node to not work as desired.

Can anyone give me a pointer as to what I might be doing wrong here?

 

Currently, the only way to get my A2B setup to work correctly with the A2B Analyzer is to write the slave registers via A2B, which is not the desired solution.

 

Thanks in advance for any help!

 

Best regards,

 

Lars

Outcomes