10 Replies Latest reply on Sep 18, 2009 10:25 AM by Joel_Pointon

    Adding pages to harness designs?

    justin.mininni

      I am new to using VeSys 2.0 and came across a question while going through the evaluation tool.  If I have a harness drawing that will not fit onto one page, is there a way to add another page to the same section?  When I go to  File > New > New Harness Design, it adds a new folder and therefore the page is then 1 of 1 instead of being 1 of 2 in the previous folder. Hopefully this is not confusing and I explained it so you can understand.

       

      Thanks