2 Replies Latest reply on Apr 28, 2010 9:24 AM by jkoogler

    DSI file issue

    jkoogler

      I  have exported a dsi file for a harness to be viewed in the Harness reports of Vesys Classic. For some reason all my parts show up in the BOM list except for the fixed tubing. This does not show up, but it is viewable in the reports in 2.0. Any ideas why this might be happening.

       

      Thanks,

      Jay

        • 1. Re: DSI file issue
          Nuri

          The VeSys Classic Harness Reports tool does not fully support the DSI created by VeSys 2.0, nor is it able to access VeSys 2.0 Components to complete the processing.  Which report are you after?

           

          Thanks,

          Nuri

          • 2. Re: DSI file issue
            jkoogler

            I ran a BOM report in both Classic and 2.0 and did a comparison and the tubing was the only thing that did not export over. The tubing and sleeve cut list shows the individual runs though.