2 Replies Latest reply on Jan 9, 2013 7:34 AM by rpurkey

    Net Properties in Pads Logic

    dila

      To change and show a new netname I use Net Properties in Pads Logic.

      1. I change the netname.

      2. I switch the Net Name Label to show on.

      3. I click OK.

      Result: the old netname and not the new netname is showing.

      This is not practicable.

       

      regards Dieter

        • 1. Re: Net Properties in Pads Logic
          jduquette

          Dieter,

           

          You are one click away!  For some reason PADS doesn't update the netname until AFTER the Net Properties dialog closes.  This means the old name shows up unitl you close the dialog.  After that the new name appears (by magic!).

          • 2. Re: Net Properties in Pads Logic
            rpurkey

            OK, I'm stumped, new to LOGIC, familiar with OrCad.

            A net shows the net name in Net Properties but the check box to show net name is greyed out.

             

            How can I make it show the name???

             

             

            edit: NEVER MIND, I FOUND IT, IT WAS SHOWING, JUST ABOUT 4 INCHES AWAY FLOATING IN SPACE.

             

            Thanks

            Russell