2 Replies Latest reply on Sep 26, 2014 9:22 AM by robert_davies

    NC symbol

    jean.stout

      I have created a NC symbol according to TechNote ID MG527127.  I add it to my design as a Special Component.  When I run the netlist I get this pin in the netlist for PCB as a single node net.  Of course PADS will delete single node nets, but I was not expecting to even see it in the netlist.   Is this as it should be?

      Thanks,

      Jean Stout

        This content has been marked as final.  Show 2 replies