4 Replies Latest reply on May 12, 2012 6:18 AM by Nuri

    Do I need to associate a library part each wire to run a simulation?

    SWSA

      Good afternoon

       

      I am using a wire library migrated from Vesys Classic to Vesys2.

       

      When I input the wire specification, the CSA is not updated, which means the simulation model wire_v2 assume it as equal to 1mm2 by default.

       

      If I input the wire library part, the CSA is properly visualized, but  i can't edit the wire color.

       

       

      Does it mean that, in my design, to run a simulation, I need to input for each wire the library part instead of just selecting the wire specification? Does it mean that the library must contain all colour combination each wire specification? (this would be very different from Vesys classic wire database, where there wasn't an association between color and specification in the wire library)

       

      Regards