0 Replies Latest reply on Feb 29, 2012 7:49 PM by wonyoung

    Number of fingers wrong in Calibreview

    wonyoung

      Whenever I run Calibre PEX and open the schematic generated by Calibreview, the number of fingers in transistors are wrong. For example, if I have a 25 finger transistor with 1um finger width (total 25um width), Calibreview gives me 25 transistors each with 25 fingers (which makes the total width 25 *25 = 625um). I tried using "m=1 fingers=1", but this did not fix the problem. I was wondering if anyone has seen this error. Thank you very much!

       

      Wonyoung