2 Replies Latest reply on Jun 7, 2012 7:51 AM by cmunoz1

    Is there process to get the harness drawing to interface properly to the symbol library and the Component library?

    cmunoz1

      I installed the latest version of Vesys to a new computer a month ago.  I imported a project, the symbol and and component library.  These files were likely saved under an old version.  I can open the complete project file as was saved.  No details are missing.  However, if I want to add and repeat a connector in the project, I get a plain default symbol for that connector without details?  This is the case even after hitting the "Refresh All".

       

      The original drawing comes up with the original details as was saved.

      Adding a duplicate connector to the drawing comes up without the assigned Component Symbol or component details.

      The component symbol is complete in the Symbol Library.

      The component details are complete in the Component library.

      There is a missing link I can't figure out.  Is there process to get the harness drawing to interface properly to the symbol library and the Component library?