I am trying to extract the s-parameter of a trace that has a series resistor in the middle of it. When I select the trace by name, it only allows me to select the entire trace with the series resistor. This would be fine, however, when I hit "create model", the GUI blinks and nothing is done (it does not ask me for a file name or anything). Is there a log file I can look at to see what happened when it tried to create the mode? All I get is this "blink" and nothing. I did assign a resistor pack model to the resistor and I assigned a value of 15 ohms.
I just picked up your service request and have sent you email directly. It is normal behavior for HypeLynx to highlight the entire net with series resistor in between. This is because the traces form one electrical net. Reply to my email so we can troubleshoot the issue with exporting s-param models. Thanks